I’ve worked on quite a few Maytag MGD5630HW dryers over the years, and radiant sensor failure is one of the more common service calls I get for this model. Most of the time the sensor itself has simply burned out or developed a weak connection at the harness — and swapping it out is usually … Read more
I’ve worked on the Maytag MGD5630HW more times than I can count, and a burner that won’t ignite is honestly one of the top three calls I get on this model. In most cases, the igniter has simply worn out — it’s a consumable part that weakens over time and eventually can’t generate enough heat … Read more
I’ve worked on quite a few Samsung DVE45T3400W dryers over the years, and a non-responsive start button is one of the more common calls I get on this model. In most cases, the culprit is either a failed door switch or a worn-out start switch assembly — both are straightforward fixes that don’t require advanced … Read more
I’ve worked on quite a few Samsung DVE45T3400W dryers over the years, and heating element relay failure is one of the more common complaints I see — usually showing up as a dryer that runs but produces no heat. In most cases, replacing the control board or the relay component itself resolves the issue completely. … Read more
I’ve worked on dozens of Samsung DVE45T3400W dryers, and drum scratching is one of the most common complaints I see with this model. In most cases, the culprit is a worn or damaged drum seal felt strip or a chipped/cracked drum glide bearing that’s developed a sharp edge. Catching it early prevents permanent damage to … Read more
I’ve worked on the Whirlpool WGD6120HW quite a bit, and the Wrinkle Shield not functioning is one of the more frequent complaints I see with this model. Nine times out of ten, it comes down to a faulty door switch or a control board issue preventing the tumble cycles from triggering after the dry cycle … Read more
I’ve worked on the Whirlpool WGD6120HW quite a bit, and idler pulley noise is honestly one of the most common calls I get for this model. That squealing or thumping sound usually means the pulley’s worn bearing has given out, and nine times out of ten, replacing the idler pulley assembly solves it completely. Dave … Read more
I’ve worked on dozens of Whirlpool WGD6120HW dryers, and igniter failure is honestly one of the most common calls I get for this model. The igniter weakens over time and eventually can’t generate enough heat to open the gas valve. Nine times out of ten, replacing the igniter itself solves the problem completely. Dave Holt … Read more
I’ve worked on the LG DLGX7701VE more times than I can count, and a dirty sensor bar is honestly one of the top five complaints I see with this model. The good news is it’s almost never a failed part — in 90% of cases, a thorough cleaning with the right materials completely resolves the … Read more
I’ve worked on the LG DLGX7701VE more times than I can count, and the Flow Sense d80/d90/d95 alert is by far the most frequent call I get on this model. In about 80% of cases, the culprit is a clogged or kinked exhaust duct — not a failed part at all. A thorough duct cleaning … Read more
