I’ve worked on quite a few Asko dishwashers over the years, and the DBI564IS door seal is one of the more common calls I get — especially on units that are 5 or more years old. The seal tends to dry out and crack along the bottom corners first, causing leaks onto the floor. In … Read more
I’ve worked on the Asko DBI564IS more times than I can count, and the E3 drain error is hands down the most common service call I get for this model. In probably 70% of cases, the fix comes down to a clogged drain pump filter or a failed drain pump impeller — both very manageable … Read more
I’ve worked on quite a few Fisher & Paykel DD24DHTX9N drawer dishwashers over the years, and a failing diverter valve is one of the more common calls I get on this model. The diverter valve controls water distribution between the spray arms, and when it fails, you’ll typically notice poor cleaning in one drawer or … Read more
I’ve worked on the Fisher & Paykel DD24DHTX9N quite a bit over the years, and Error 1 is honestly one of the most frequent calls I get on this model. In most cases, the culprit is either a kinked water supply hose, a clogged inlet valve screen, or a faulty water inlet valve — and … Read more
I’ve worked on dozens of Fisher & Paykel DD24DHTX9N drawer dishwashers over the years, and drawer alignment issues are one of the most common service calls I get for this model. Nine times out of ten, the fix comes down to worn drawer glide rails or a bent drawer hinge bracket — both of which … Read more
I’ve worked on quite a few Thermador DWHD650WFM units over the years, and turbidity sensor errors are one of the most frequent service calls I get for this model. Nine times out of ten, the sensor itself is either fouled with hard water deposits or has simply failed — and a straightforward cleaning or replacement … Read more
I’ve worked on the Thermador DWHD650WFM quite a bit, and the water hardness sensor error is one of the more frequent calls I get on this model. In most cases, the fix comes down to either a clogged or failed water softener salt sensor rather than anything major. A good cleaning or straightforward sensor replacement … Read more
I’ve worked on quite a few Thermador DWHD650WFM units over the years, and StarDry failure is one of the more frequent complaints I see with this model. In most cases, the culprit is a failed zeolite drying module or a faulty NTC temperature sensor that’s lost communication with the control board. The good news is … Read more
I’ve worked on the Cove DW2450 quite a bit, and the wash arm connection issue is one of the more frequent calls I get on this model. In most cases, the plastic retaining clip or the wash arm hub fitting has cracked or warped, causing poor water distribution. Replacing the connection assembly usually does the … Read more
I’ve worked on the Cove DW2450 more times than I can count, and Error 23 is one of the most frequent calls I get for this machine. It almost always points to a faulty water inlet valve or a flow sensor issue preventing proper fill. The good news is this is a very fixable DIY … Read more
