I’ve worked on the KitchenAid KDFE204KPS more times than I can count, and sump motor failure is honestly one of the most common calls I get on this model. Nine times out of ten, the motor wash impeller has worn out or the motor itself has seized due to debris buildup — and replacing the … Read more
I’ve worked on the KitchenAid KDFE204KPS more times than I can count, and a stuck float switch is one of the most common calls I get on this model. In my experience, it’s usually caused by mineral buildup or debris trapping the float in the up position, which tricks the control board into thinking the … Read more
I’ve worked on the LG LDF7774ST quite a bit over the years, and third rack alignment issues are one of the most common complaints I see with this model. Nine times out of ten, the problem comes down to worn or misaligned rack guides and stop clips on the upper rack rail assembly. The good … Read more
I’ve worked on the GE Profile PDT755SYRFS more times than I can count, and AutoSense load detection issues are one of the most frequent calls I get on this model. Nine times out of ten, the culprit is a faulty turbidity sensor or a compromised wire harness connection near the sump assembly. Once you identify … Read more
I’ve worked on the GE Profile PDT755SYRFS quite a bit over the years, and hard food disposer noise is one of the most common complaints I hear from owners of this model. Nine times out of ten, the culprit is a worn or damaged hard food disposer assembly, and the fix is more straightforward than … Read more
I’ve worked on the LG LDF7774ST more times than I can count, and a pump filter clog is hands down the most common service call I get for this model. In most cases, a thorough cleaning of the filter assembly and sump area is all it takes to get it draining properly again — no … Read more
I’ve worked on dozens of Bosch 300 Series dishwashers, and the rack rail not sliding is honestly one of the most common calls I get on the SHSM63W55N. Nine times out of ten it’s either a cracked or warped rack rail adjuster or debris-clogged roller wheels causing the binding. The good news is this is … Read more
I’ve worked on the GE Profile PDT755SYRFS quite a bit, and panel disconnect is one of the more frequent calls I get on this model. In most cases, the culprit is a faulty control panel ribbon cable or a failed user interface board that’s lost its connection. The good news is this is very fixable … Read more
I’ve worked on dozens of LG LDF7774ST dishwashers over the years, and the AE error is one of the most common calls I get for this model. In about 80% of cases, the culprit is a failed door gasket or a cracked sump assembly allowing water into the base pan and triggering the float sensor. … Read more
