I’ve worked on the KitchenAid KOCE500ESS combo unit more times than I can count, and lower oven fan noise is one of the most common calls I get on this model. In most cases, the culprit is a worn convection fan motor or a warped fan blade that’s developed wobble over time. The good news … Read more
I’ve worked on the Thermador ME301YS more times than I can count, and the F34 error is one of the most frequent calls I get for this model. It points to an oven temperature sensor fault, and in about 80% of cases, replacing the oven temperature sensor probe clears it completely. Occasionally the control board … Read more
I’ve worked on the Bosch HBL8651UC more times than I can count, and the E118 error is one of the most frequent service calls I get for this model. It signals a fault in the oven temperature sensor circuit, and in my experience, roughly 80% of cases are resolved simply by replacing the oven temperature … Read more
I’ve worked on the Bosch HBL8651UC quite a bit over the years, and EcoClean not working is one of the more frequent complaints I see with this model. Nine times out of ten, it comes down to a faulty door latch assembly or a failed EcoClean panel coating that’s been damaged by improper cleaning products. … Read more
I’ve worked on the KitchenAid KOCE500ESS combo unit more times than I can count, and Sabbath mode getting stuck or failing to reset is one of the most common calls I get on this model. Nine times out of ten, the fix is a simple control board reset sequence or a firmware-related power cycle — … Read more
I’ve worked on the Samsung NV51K7770DS quite a bit over the years, and the Flex Duo probe error is one of the most frequent service calls I get for this model. Nine times out of ten, the culprit is either a faulty meat probe or a damaged probe socket port on the oven cavity. The … Read more
I’ve worked on the Samsung NV51K7770DS quite a bit over the years, and a broken door handle is honestly one of the most frequent calls I get on this wall oven. The handle mounting points tend to stress-crack over time, especially with heavy daily use. In most cases, a straightforward handle assembly replacement gets it … Read more
I’ve worked on dozens of KitchenAid KOCE500ESS combo units over the years, and the microwave combo error is one of the most common calls I get on this model. In most cases, it comes down to a failed control board or a faulty door interlock switch causing communication errors between the two cooking systems. Dave … Read more
I’ve worked on the GE JTS5000SNSS quite a few times, and convection motor failure is one of the most common service calls I get on this unit. You’ll usually notice uneven baking or the convection fan simply not spinning during a convection cycle. In most cases, replacing the convection fan motor assembly solves the problem … Read more
I’ve worked on the Samsung NV51K7770DS quite a bit over the years, and steam clean failures are one of the most frequent calls I get on this model. In most cases, the culprit is either a clogged or failed steam generator assembly or a faulty water inlet valve that’s preventing water from reaching the steam … Read more
