I’ve worked on the KitchenAid KRFC704FPS quite a bit over the years, and cooling issues on this model are more common than you’d think — especially in units that are 3–5 years old. In most cases, a failed adaptive defrost control board is the primary culprit, causing frost buildup that blocks airflow and kills cooling … Read more
I’ve worked on the KitchenAid KRFC704FPS more times than I can count, and a dead ice maker is easily the most common service call I get for this model. In most cases, the shut-off arm gets bumped into the off position or the ice maker assembly itself fails — both are straightforward fixes any careful … Read more
I’ve worked on dozens of Frigidaire FRSS2623AS units over the years, and water pooling on the floor is honestly one of the most common calls I get for this model. Nine times out of ten, it’s a clogged defrost drain or a cracked drain pan — both totally fixable without replacing major components. Catch it … Read more
I’ve worked on the Frigidaire FRSS2623AS more times than I can count, and a cooling issue on this model is almost always traced back to a failed compressor start relay or heavily clogged condenser coils. This is honestly one of the most common service calls I get for this side-by-side, and the good news is … Read more
I’ve worked on the Frigidaire FRSS2623AS more times than I can count, and ice maker failure is hands-down the most common service call I get for this model. In most cases, the ice maker module itself has burned out, though a faulty water inlet valve is a close second culprit. Replacing the module usually gets … Read more
I’ve worked on the GE GFE26JSMSS quite a bit over the years, and a warm fresh food section is one of the most common calls I get on this French door model. In the majority of cases, the culprit is either a failed damper control assembly or a faulty thermistor throwing off temperature regulation. Catch … Read more
I’ve worked on the GE GFE26JSMSS more times than I can count, and a freezer that’s not cold enough is one of the most common calls I get on this French door model. In probably 70% of cases, the culprit is a failed defrost heater or a stuck defrost timer causing frost buildup on the … Read more
I’ve worked on dozens of GE GFE26JSMSS French Door refrigerators over the years, and icemaker leaks and overflows are easily one of the top three complaints I see with this model. Nine times out of ten, the culprit is a misaligned fill tube combined with excessive water inlet pressure, which causes overfilling and spillage into … Read more
I’ve worked on dozens of Whirlpool WRF535SWHZ refrigerators over the years, and a dead water dispenser is one of the most frequent calls I get on this model. About 60% of the time, it’s a failed dispenser switch or a clogged water inlet valve — both are straightforward fixes most homeowners can handle themselves. Dave … Read more
I’ve worked on the Whirlpool WRF535SWHZ more times than I can count, and a no-cooling complaint almost always traces back to a failed start relay or a seized compressor. This is one of the most common calls I get on this French door model, and the good news is the start relay fix is something … Read more
